STOP&GO 7 PLUS-MINUS high-voltage device with ultrasound

STOP&GO 7 PLUS-MINUS High-voltage device with ultrasound

Double stainless steel contact plates – connects to on-board power supply – ultrathin design

The connection to terminal 15 has been replaced by sensor technology, and a slide contact attached directly to the device eliminates the need to install a bonnet contact switch. Minimal power consumption.

We also highly recommend using the STOP&GO marten odour remover prior to taking any other marten protection measures.

Additional features:

• 12-volt connection
• Sensor technology
• Power consumption: approx. 0.2 mA
• 6 stainless steel contact plates with a plus and minus pole
• 2 waterproof piezo speakers
• Dispersion radius: 360°
• Dispersion angle: > 170°
• Sound pressure: approx. 110 dB
• Frequency modulation to prevent habituation
• Function control light, blinking LED
• Waterproof in accordance with IP65
• Panic protection control
• Compatible with CAN data bus
• E1 marking by the German Federal Motor Transport Authority (KBA)

Technical data:

• Operating voltage: 12 V
• Power consumption: approx. 0.2 mA (including after a short circuit)
• Reverse polarity protection: is provided
• Fuse in the fuse holder: 0.5 A F
• High voltage: yes
• Output voltage: ca. 300 V
• Ultrasound: yes
• Ultrasound frequency: 20–25 KHz, frequency modulation
• Dispersion radius: 360°
• Dispersion angle: > 170°
• Sound pressure: approx. 110 dB
• Function control light: red LED
• Moisture protection: waterproof in accordance with IP65